Skip to content
English
  • There are no suggestions because the search field is empty.

Understand sensor setup status

Find out what each device colour means and how to continue an incomplete setup.

When you scan for nearby sensors, PlantOS displays a coloured card for each device. The colour tells you how far the device has progressed through setup and what you need to do next.

These colours describe device setup status. They are separate from equipment health indicators and prescription statuses.

Check your sensor’s status

  1. Open the Home Dashboard.
  2. Tap + Device.
  3. Select the plant if prompted.
  4. Tap Scan Nearby Sensors.

Make sure Bluetooth is enabled, the app has the required permissions and you’re close to the sensor.

What do the colours mean?

Colour Setup status Your next step
Blue New device. It isn’t assigned to a plant or measurement location. Complete the full setup process.
Amber Partially configured. It’s assigned to a plant but isn’t linked to a measurement location. Complete measurement location mapping.
Yellow Communication incomplete. It’s assigned to a plant and measurement location, but communication setup is incomplete or has failed. Review Wi-Fi settings and retry connectivity checks.
Green Fully configured and actively monitoring. No further onboarding is required.

Blue: Start a new setup

Tap the blue device card to begin.

You’ll need to:

  1. Register the device.
  2. Assign a measurement location.
  3. Add installation photos if required.
  4. Configure Wi-Fi.
  5. Complete cloud configuration where applicable.
  6. Pass the required connectivity checks.

For the full instructions, see Add and configure a sensor.

Amber: Complete measurement location mapping

An amber device has been registered to a plant but still needs a measurement location.

A measurement location (ML) is the point on an asset where the sensor collects monitoring data.

To continue:

  1. Tap the device card.
  2. Select an existing, unmapped measurement location or create a new one through the hierarchy flow.
  3. Complete the mapping.
  4. Continue through the remaining setup steps.

Measurement location mapping is mandatory. You can’t continue until it’s complete.

Yellow: Complete communication setup

A yellow device is already assigned to a plant and measurement location, but its communication setup needs attention.

To continue:

  1. Tap the device card to open Wi-Fi setup.
  2. Check the network name, password and authentication type.
  3. Confirm the network is active and the sensor is within range.
  4. Continue through setup and retry the connectivity checks.

Edit options are available if you need to change the device configuration.

Green: Setup is complete

A green device is fully configured and actively monitoring. You don’t need to register it again.

For vEdge and Eqsense, tapping the card opens Monitor Device, where you can review live device communication. FitMachine does not use the same Monitor Device screen.

After setup, also confirm that monitoring data is available for the correct measurement location.

Sensor not appearing?

If the sensor doesn’t appear in the scan:

  • Check that Bluetooth is enabled.
  • Confirm the app has Bluetooth and location permissions.
  • Move closer to the sensor.
  • Check that the sensor is powered on.
  • Scan again.

Related article

Add and configure a sensor